How To Fix Stopper In Bathroom Sink

Introduction

Having a drain stopper that doesn't work can be a real pain, especially in the bathroom sink. It can cause water to drain slowly or not at all, leading to a clogged sink and potential water damage. But don't worry, fixing a stopper in your bathroom sink is a relatively easy task that you can do yourself with a few simple tools.

Step 1: Remove the Stopper

The first step in fixing a stopper in your bathroom sink is to remove it. To do this, you'll need to locate the pivot rod that runs through the back of the drain pipe. Once you locate it, loosen the nut on the pivot rod and pull it out. This will allow you to remove the stopper from the sink.

Step 2: Clean the Stopper and Drain

Once you've removed the stopper, you'll want to clean it and the drain thoroughly. Use a rag or sponge to remove any debris, hair, or soap scum that may be clogging the drain. Next, clean the stopper itself, making sure to remove any buildup that may be preventing it from working properly.

Step 3: Reassemble the Stopper

After you've cleaned the stopper and drain, it's time to reassemble the stopper. Make sure the pivot rod is securely in place, then slide the stopper back into the drain. Tighten the nut on the pivot rod, making sure it's snug but not too tight.

Step 4: Test the Stopper

Once you've reassembled the stopper, run some water in the sink to test it. Make sure the stopper goes up and down properly and that water drains freely. If it doesn't, you may need to repeat the cleaning process or adjust the pivot rod slightly.

Conclusion

Fixing a stopper in your bathroom sink is a relatively easy task that you can do yourself with a few simple tools. By following these steps, you'll be able to keep your sink draining properly and prevent potential water damage.